![]() An example is a windmill built directly on top of a gear with no floor: in this case, disconnecting the gear via the lever will cause the windmill construction to collapse. The same is true of a horizontally connected hanging device. However, be warned that if a device is supported entirely by a gear, it may collapse when the gear is disconnected. Gears can be "disconnected" by being connected to a lever, and then pulling that lever. They can also be built on stair tiles, however they will not transfer power through z-levels when placed like that. Then place either another gear assembly, a vertical axle, or a machine (screw pump, etc.) on the z-level below in the same square, and power will be routed to it. In order to transfer power between z-levels with a gear assembly, you must first dig a channel, and then place the gear over the opening. Note that gear assemblies do not transfer power diagonally they only work orthogonally (N–S, E–W, up–down). ![]() Further components can then be connected to the other available sides (East, West, North, South, Above, Below) of the gear assembly, and will automatically draw power from the power source via the assembly. They require one mechanism to construct.Īfter the gear assembly has been constructed, it will automatically draw power from an adjacent power source. Gears can be constructed from the build menu under Machine Components and gear. However, digging a channel to transfer the power (such as for an axle or a pump) below a gear assembly can result in a hole that cannot be crossed.įor a basic overview of how the different machine parts work and work together, see machinery. Gear assemblies do not block unit movement and can be crossed by dwarves without danger. Gear assemblies require 5 units of power each. A screw pump can be used to change the direction of power flow without using a mechanism (for instance when metal and stone are unavailable). A gear assembly is constructed from a single mechanism. ![]() Gear assemblies are required to change the direction of power flow, whether a horiztonal x- and y-axis change on the same z-level, or a change between vertical ( z-axis) and horizontal (either x- or y-axis) to/from a differant z-level – that is, any change of 90°. A gear assembly is a machine component that is used to transmit power from one adjacent machine component to another, such as water wheels, windmills, axles, screw pumps, millstones and other gear assemblies. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |